- whatsapp +51955515985
- support@ecuforcetruck.com
- 24/7 Customer Support
Menu
Shop
Account
Subtotal: $0.00
No products in the cart.
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 4152 PID: SPN: 5743 FMI: 9 Aftertreatment Selective Catalytic Reduction Temperature Sensor Module- Abnormal Update Rate
Circuit Description
The aftertreatment SCR (selective catalytic reduction) temperature sensor module is a smart device that communicates with the engine control module via the J1939 data link. The aftertreatment SCR temperature sensor module performs its own internal diagnostics and reports malfunctions back to the engine control module using the J1939 data link. The aftertreatment SCR temperature sensor module is used to measure the aftertreatment SCR intermediate temperature and aftertreatment SCR outlet temperature. The temperature probes are permanently attached to the aftertreatment SCR temperature sensor module and can not be replaced individually.
Component Location
The aftertreatment SCR temperature sensor module is mounted on the aftertreatment SCR catalyst.
Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.
Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected a loss of communication with the aftertreatment SCR temperature sensor module.
Action Taken When the Fault Code is Active
1)The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
2)Diesel exhaust fluid injection into the aftertreatment system is disabled.
3)Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
4)For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.
Possible causes:
1) Low battery voltage supply
2) Incorrect terminating resistance of the SAE J1939 datalink circuit
3) Incorrect sensor for the application (12 VDC versus 24 VDC)
4) Incorrect Battery System Voltage setting in INSITE
Related
Categories Cumminz, ISB6.7 CM2350 (2013-17)Tags 17, 2013, 4152, 5743, 9, Abnormal, Aftertreatment, Catalytic, CM2350, Code, Cummins, Fault, FMI, ISB6.7, Module, PID, Rate, Reduction, Selective, Sensor, SPN, Temperature, Update
Wiring Diagrams
Component Locators
- Allison DOC 2021 V2 (1PC)
Allison$67.00
Rated 0 out of 5
- download JPRO 2023 1.2 off-highway – on-highway
JPRO$96.00
Rated 0 out of 5
- Diamond Logic Builder DLB 2019 Database 2019
Navistar$50.00
Rated 0 out of 5
- Bendix 6.16 ACom Diagnostics ( bendix software trucks )
Bendix$35.00
Rated 0 out of 5
- Hino DX3 1.22.10 2022 ( 1 PC )
Hino$96.00
Rated 0 out of 5
Related products
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3312 PID: SPN:3246 FMI:0 Aftertreatment 1 Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Most Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3318 PID: SPN:3242 FMI:2 Aftertreatment 1 Diesel Particulate Filter Intake Temperature – Data Erratic, Intermittent, or Incorrect
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3261 PID:SID 254 SPN:4342 FMI:5 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 2 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3315 PID: SPN:4765 FMI:2 Aftertreatment 1 Diesel Oxidation Catalyst Intake Temperature – Data Erratic, Intermittent, or Incorrect
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3313 PID: SPN:4765 FMI:4 Aftertreatment 1 Diesel Oxidation Catalyst Intake Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3254 PID: SPN:3242 FMI:15 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3231 PID: SPN:4360 FMI:16 Aftertreatment SCR Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3235 PID: SPN:4363 FMI:16 Aftertreatment SCR Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3253 PID: SPN:3242 FMI:16 Aftertreatment Diesel Particulate Filter Intake Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3256 PID: SPN:3246 FMI:0 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Least Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3235 PID: SPN:4363 FMI:0 Aftertreatment SCR Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3316 PID: SPN:3242 FMI:4 Aftertreatment 1 Diesel Particulate Filter Intake Temperature Sensor Circuit – Voltage Below Normal or Shorted to Low Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3237 PID:SID 254 SPN:4340 FMI:3 Aftertreatment 1 Diesel Exhaust Fluid Line Heater 1 Circuit – Voltage Above Normal or Shorted to High Source
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:332 PID:SID 4 SPN:654 FMI:5 Injector Solenoid Driver Cylinder 4 Circuit – Current Below Normal or Open Circuit
DTC TRUCKS
Rated 0 out of 5
- PACCAR PX-9 CM2350 (2013-17) Fault Code:3255 PID: SPN:3246 FMI:0 Aftertreatment Diesel Particulate Filter Outlet Temperature – Data Valid But Above Normal Operating Range – Moderately Severe Level
DTC TRUCKS
Rated 0 out of 5
- MANUAL SERVICE DEUTZ AGROTRON TTV 1130-1145-1160
DEUTZ$32.00
Rated 0 out of 5
- SERVICE MANUAL Eaton Gen III Automated TransmissionsTRSM0930 EN-USOctober 2020
TRUCK MANUALS$24.00
Rated 0 out of 5
FUSO$27.00
Rated 0 out of 5
- MANUAL SERVICE DEUTZ AGROLUX F50-F60-F70-F80
DEUTZ$25.00
Rated 0 out of 5
INTERNATIONAL ENGINES$31.00
Rated 0 out of 5
INTERNATIONAL ENGINES$20.00
Rated 0 out of 5
- SERVICE MANUAL Carrie CT3-69-TV
CARRIE$20.00
Rated 0 out of 5
- SERVICE MANUAL EPA04 Series 60 DDEC V Actuator Adjustment
DETROIT$18.00
Rated 0 out of 5
- SERVICE MANUAL Carrie Integra 30s
CARRIE$20.00
Rated 0 out of 5
INTERNATIONAL ENGINES$24.00
Rated 0 out of 5